Z-Wave Tubular Motor
The Z-Wave Tubular Motor is a Z-wave blinds & covers by Cherubini Spa. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Setup instructions
1) Prepare the Z-Wave controller for inclusion of a device (see your controller's instructions). 2) On the motor, run the programming sequence for inclusion: a. By the remote control: AB - AC - AB (2 seconds), wait for confirmation movements. b. By the button (if the end stops are not adjusted, you can use either sequence indifferently): i. With the motor on the high limit switch: UP-UP-UP-UP-UP-DOWN. ii. With the motor on the low limit switch: DOWN-DOWN-DOWN-DOWN-DOWN-UP. 3) The motor performs a few short movements to signal that the inclusion procedure is in progress. 4) Check the controller to verify that the procedure was successful.
Frequently asked questions
Does the Z-Wave Tubular Motor work with Home Assistant?
Yes — the Z-Wave Tubular Motor is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the Z-Wave Tubular Motor use?
The Z-Wave Tubular Motor communicates over Z-Wave.
Data: zwave
← Back to results