Door/Window Sensor

Auto inclusion The detector supports the auto inclusion feature where it will automatically enter Inclusion mode when first powered up. This will also apply when powered up after a factory reset. 1. Put a Z-Wave controller into inclusion mode. 2. Remove the strip of insulating film from the battery cover on the front of casing. The LED on the device should turn ON 3. The inclusion process should be completed when the LED stops blinking 4. Perform test before you refit the battery cover. Manual inclusion You can also choose to manually add the Z-Wave device to a control device. Please follow the steps described below. Note For best results, exclude the device before starting the inclusion process. For more details see the installation guide 1. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode. 2. The inclusion process should be completed when the LED stops blinking 3. Perform a test before you refit the cover