The PIR Motion Sensor is a Z-wave sensors by Sercomm Corp. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Shop Sercomm Corp on Amazon
Browse current Sercomm Corp smart home products and deals on Amazon.
Featured Sercomm Corp devices
See all →Setup instructions
1. Install the battery and the Pairing LED indicator will be lit for one second to indicate a successful booting. 2. It will blink one time every second while scanning the network. 3. If the network is not found after 30 seconds, the sensor will go into sleep mode. To wake the sensor again, you need to use the tamper switch to trigger the adding (Inclusion) process, and then the sensor will repeat steps from 2 to 3.
Frequently asked questions
Is the PIR Motion Sensor compatible with Home Assistant?
Yes — the PIR Motion Sensor is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the PIR Motion Sensor use?
The PIR Motion Sensor communicates over Z-Wave.
Data: zwave
← Back to results