The DoorWindow Sensor is a Z-wave sensors by Sercomm Corp. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Shop Sercomm Corp on Amazon
Browse current Sercomm Corp smart home products and deals on Amazon.
Featured Sercomm Corp devices
See all →Setup instructions
First install 1. Pull the exposed plastic tab from the sensor. 2. Power on 3. The Green LED indicator will be lit for one second to indicate a successful booting. 4. It will blink one time every second while scanning the network. 5. If network is not found after 30 seconds, the sensor will go into sleep mode. To wake the sensor again, you need to use magnet or tamper to trigger a Add (Inclusion) process, and then sensor will repeat steps from 3 to 4.
Frequently asked questions
Is the DoorWindow Sensor compatible with Home Assistant?
Yes — the DoorWindow Sensor is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the DoorWindow Sensor use?
The DoorWindow Sensor communicates over Z-Wave.
Data: zwave
← Back to results