The Magnetic Contact is a Z-wave other by China Security & Fire IOT Sensing CO., Ltd.. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Shop China Security & Fire IOT Sensing CO., Ltd. on Amazon
Browse current China Security & Fire IOT Sensing CO., Ltd. smart home products and deals on Amazon.
Featured China Security & Fire IOT Sensing CO., Ltd. devices
See all →Setup instructions
For Inclusion to a network: Put the Z-Wave Interface Controller into 'Inclusion' mode, and following its instruction to include HO-09ZB to your controller. This magnetic contact needs to be included before installation. 1. Pull out the insulating strip, making the device power on. 2. Pressing the anti-tamper switch three times. 3. Red LED will blink three times while inclusion the network successful 4. If inclusion failed, the sensor will go into sleep mode. To wake the sensor again, you need to use magnet or anti-tamper switch to trigger an inclusion process, and then sensor will repeat steps from 3 to 4
Frequently asked questions
Does the Magnetic Contact work with Home Assistant?
Yes — the Magnetic Contact is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the Magnetic Contact use?
The Magnetic Contact communicates over Z-Wave.
Data: zwave
← Back to results