The Water Leak Detector is a Z-wave sensors by Zwaveproducts.com. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Shop Zwaveproducts.com on Amazon
Browse current Zwaveproducts.com smart home products and deals on Amazon.
Featured Zwaveproducts.com devices
See all →Setup instructions
Inclusion: Add the device into your network by a Z-Wave certified controller. If the controller is SmartStart compatible, refer to the controller manufacturer app that allows the DSK code to be scanned, and scan the DSK code on the inside of the battery door or on the box. If your controller is not S2/ SmartStart compatible, the device can be added using the traditional method for Z-Wave as follows: 1. Place your controller into Inclusion (Add) mode by following the controller manufacturer's instructions. 2. When the controller is ready, single click the button of LD-100. The controller should indicate that the new device was added successfully. If the controller shows it failed, repeat the procedure
Frequently asked questions
Is the Water Leak Detector compatible with Home Assistant?
Yes — the Water Leak Detector is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the Water Leak Detector use?
The Water Leak Detector communicates over Z-Wave.
Data: zwave
← Back to results