Z-Wave 700 Keypad

Add the Keypad into the Z-Wave network via SmartStart: 1. Add Keypad DSK into the primary controller SmartStart Provisioning List (If you don't know how to do this, refer to its manual). 2. Power on the Keypad again. 3. The Keypad will send 'Z-Wave protocol Command Class' frame to start SmartStart Inclusion. 4. Network green LED will flashing at every 1 second to indicate that the inclusion is working, and solid green LED 3 seconds for indicate the inclusion is successful, otherwise the LED will be soild yellow in which you need to repeat the process from step 2 Note: Keypad will reset itself to factory default by sending 'Device Reset Locally CC' when it is included into a non-security Z-wave network. DSK QR code is on the left side of the product with laser printing. User should follow the procedure in the section below if the controller does not support SmartStart inclusion. Add the Keypad into the Z-Wave network: 1. Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual). 2. Trigger this action. 3. Network green LED will flashing at every 1 second to indicate that the inclusion is working, and solid green LED 3 seconds for indicate the inclusion is successful, otherwise the LED will be soild yellow in which you need to repeat the process from step 2.