The DoorSensor is a Z-wave sensors by Shenzhen Easyhome Technology Co., Ltd.. It works with Home Assistant.
Compatibility
Compatibility data may be incomplete. Useorto indicate whether it matches your experience.
Shop Shenzhen Easyhome Technology Co., Ltd. on Amazon
Browse current Shenzhen Easyhome Technology Co., Ltd. smart home products and deals on Amazon.
Featured Shenzhen Easyhome Technology Co., Ltd. devices
See all →Setup instructions
For Adding in (Inclusion) a network: Put the Z-Wave Interface Controller into 'Add (Inclusion)' mode, and following its instruction to add ZWDS01-US to your controller. This Door/Window sensor needs to be included before installation. 1. Pull the exposed plastic tab from the sensor. 2. Press the button three times within 2 seconds, The Red LED indicator will be flashing three times to indicate scanning the network. 3. If network is not found after 30 seconds, the sensor will go into sleep mode. To Adding again, you need repeat steps 2
Frequently asked questions
Does the DoorSensor work with Home Assistant?
Yes — the DoorSensor is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.
What protocol does the DoorSensor use?
The DoorSensor communicates over Z-Wave.
Data: zwave
← Back to results